Follow

config.system.time.ntp_diagnostics 

ROLE: Admin 

Description

Display the InfiniBox NTP status. 

Syntaxconfig.system.time.ntp_diagnostics 
Exampleconfig.system.time.ntp_diagnostics 
NODE 1 TALLY REMOTE REFID STRATUM TYPE WHEN (SEC) POLL (SEC) REACH DELAY (MS) OFFSET (MS) JITTER (MS) candidate node-2 172.20.255.1 4 UNICAST 41 64 377 0.042 0.398 0.031 candidate node-3 172.20.255.1 4 UNICAST 55 64 373 0.036 0.769 0.105 sys.peer 172.20.255.1 103.245.79.18 3 UNICAST 336 1024 377 0.752 0.132 0.106 NODE 2 TALLY REMOTE REFID STRATUM TYPE WHEN (SEC) POLL (SEC) REACH DELAY (MS) OFFSET (MS) JITTER (MS) candidate node-1 172.20.255.1 4 UNICAST 42 64 376 0.021 -0.403 0.029 candidate node-3 172.20.255.1 4 UNICAST 39 64 377 0.042 0.396 0.028 sys.peer 172.20.255.1 103.245.79.18 3 UNICAST 451 1024 377 0.976 -0.274 0.181 NODE 3 TALLY REMOTE REFID STRATUM TYPE WHEN (SEC) POLL (SEC) REACH DELAY (MS) OFFSET (MS) JITTER (MS) candidate node-1 172.20.255.1 4 UNICAST 56 64 356 0.005 -0.828 0.089 candidate node-2 172.20.255.1 4 UNICAST 56 64 376 0.019 -0.471 0.072 sys.peer 172.20.255.1 103.245.79.18 3 UNICAST 430 1024 377 0.678 -0.869 0.458Filesystem 'fs1' was assigned to policy 'q2'



config.system.time.set_ntp 

ROLE: Admin 

Description

Set NTP servers. 

Syntaxconfig.system.time.set_ntp primary=HOSTNAME [secondary=HOSTNAME] 
Argumentssecondary A valid hostname or IPv4 address 
primary A valid hostname or IPv4 address 
Exampleconfig.system.time.set_ntp primary=ntp1 
NTP server set to ntp1 


Was this article helpful?
0 out of 0 found this helpful

0 out of 0 found this helpful

Last edited: 2022-08-06 08:33:54 UTC

Comments