This article describes the setting required for multipath to work on a HP-UX host.

This is a manual configuration step that is currently not supported in Host Power Tools.

Manual configuration guide

Native multipathing is active and properly configured in a HP-UX host. You can verify that the round-robin policy is active for a SCSI disk device using:

bash-4.3# scsimgr get_info -D /dev/rdisk/disk15
        STATUS INFORMATION FOR LUN : /dev/rdisk/disk15
I/O load balance policy                       = round_robin

The multipath topology can be shown using:

ioscan -m dsf
Was this article helpful?
0 out of 0 found this helpful

0 out of 0 found this helpful

Last edited: 2022-08-06 08:23:54 UTC